Okay, so, I just bought Skyward Sword, and I bought a Wii Remote Plus to go with.
So I get it synced, it works fine, I start the game, and, after calibration...nothing. It won't sense the Wii remote's movement. I restart the system, and, again, the remote works fine, until Skyward Sword does it's calibration, and, again, it fails to work. I got it to work once, but when I started a tutorial (Which I figured would be a good idea) it stopped working, and I haven't been able to replicate that. A few times, it picked it up for a split second, but I wasn't able to get it to work right more than that.
What's worse, there's no information available on this. It's all people complaining about the controls for Skyward Sword, or complaining about people complaining about the Skyward Sword controls, or, worse, the same generic "solutions" that people always say but never work. (Clean the sensors, restart the system, bullshit like that)
The problem might be that I'm using a third-party wireless sensor bar, and if that is the problem, then I am properly **** here. Can anyone help? Thanks in advance!
EDIT: Okay, a mix of timing, luck, and a little bit of skill managed to get it working (Basically hitting a sweet spot, so to speak, and hitting A...it's like Nintendo's writing their own jokes into the programming now) Still, if anyone could figure out a better solution, that would be appreciated.
