SkyWarpsGhost wrote:What's the best way to get pins out of joints?
I'm planning on repainting 2 dotm Sideswipes as G1 Sideswipe and SunStreaker.
fotfom wrote:Hi all
I'm finishing up a repaint of Impossible Toys Medic (which I got in BBTS clearance) as Arcee. This is the first figure, or anything for that matter, I've actually repainted in any seriousness and I'm just about done but was wondering about a sealant.
Since her body is only held together by about two screws and the rest are tiny little clip/hinges I was wondering if anyone had any recommendations for a sealant that would work well for the tiny moving parts, or if it will make any difference at all.
And if it's an option (I have no idea) a low gloss or unnoticeable finish to suit the classic figures better.
Thanks in advance
Hotwire Customs wrote:Testors Dullcoate is about as good as it comes. However, if the moving parts you mention rub on each other, even a sealant won't stand up to too much movement. Check for paint rub issues before you seal it.
Arlekkin wrote:I've been trying to remove the pins from the lower leg of Tomahawk, but the pin won't budge (even after hammering). Should I heat a bit the plastic (with a hairdryer) before hammering?
ricemazter wrote:I'm trying to do a headswap between the walmart exclusive dotm bumblebee and rotf deluxe soundwave. So far I've simply been trying to plug soundwave's head into the bumblebee body, but that hasn't been working. It looks like either the plastic on the head sticks too far from the socket for bumblebee's peg to fit it or the pastic around bee's peg is conflicting with the head I'm not sure. Does any one have any ideas on what I should do? This is my first attempt at something like this besides a sideswipe repaint so forgive my naivete. If I should shave down the plastic how would I go about doing it? I'm thinking that I should probably shave off around the ball peg because I'm afraid of ruining the socket on soundwave's head. Any advice on this would be great.
You have the right idea with shaving the ball on the head. I'd suggest using some 1000 grit sand paper(automotive type is fine) or using a nail file and then smoothing off with the sand paper. Go slowly and test fit it often, as you can easily sand more and don't want to take off too much. Good luck and have fun customizing
Mindewipe24 wrote:Hey guys I was browsing for a pin punch online today and came across this tool. I was wondering what you guys think, and if it would be anygood for removing pins instead of the pin punch, hammer method.
http://www.ebay.com/itm/Jewelers-Deluxe ... vi-content
grimdragon2001 wrote:hey guys, not sure if this was asked before, but what do you guys think of using nail polish as paints for figures? been experimenting with the idea after finding colors ive been looking for in the polishes that i cant find in normal model paints.
chaosmage42 wrote:im interested in knowing how to make new heads or other parts for figure -ive been wanting to try a few things
making an iron fist -would need a head
some of the shattered glass characters -repaints and i would need different heads for some
also an idea i have for turning bumble bee second printing form primes into a shattered glass version the generic troops form primes -his arm cannons and the fact they attach in car mode gave me the idea
SW's SilverHammer wrote:Eat my ass funpub.