The Energon Pub

Big thanks to everyone who has combined the G1 and Energon parts together before me, this is my version of it ..wanted the claw on the correct side, that was very important and it to look very G1 but upgraded, didn't go mad on the detailing, sometimes less is more

He's fully transformable, the head is held on by magnets so pulls off to attach to his tank and you get a full range of articulation with it, here's a few quick pictures, will add better ones tomorrow with alt modes too ...thanks for looking

Looks sharp. Great use of both molds.

deliciouspeter wrote:Looks sharp. Great use of both molds.

Thanks bud

Damn he looks good!

Burn wrote:Damn he looks good!

Thanks man

This guy looks amazing! Great work!

donny1975 wrote:This guy looks amazing! Great work!

Thanks bro

that is amazing . who knew the Energon and G1 Omega supreme molds work together to make one Bad A$$ figure ?

Autobot tap out wrote:that is amazing . who knew the Energon and G1 Omega supreme molds work together to make one Bad A$$ figure ?

Cheers bro! ...them smileys i bet these would sell well but the problem is there not cheap to make with the G1 Supreme costing £100 on it's own

this is one of the best G1 Omega Supreme updates/customs i've ever seen. I really wish we'd get an official one after all these years. Great work!

Mass Prime wrote:this is one of the best G1 Omega Supreme updates/customs i've ever seen. I really wish we'd get an official one after all these years. Great work!

Thanks man ...i hope they do a Titan wars Supreme, we really need a big updated version of this bad boy!

I know! At least Devastator size since he's his nemesis. How tall is yours? 16-17" I guess right/ He looks close.

Mass Prime wrote:I know! At least Devastator size since he's his nemesis. How tall is yours? 16-17" I guess right/ He looks close.

I think he's about 14inches, will do a size comparison with Titan Dev when he arrives but sadly, i think he will tower over him