MP Scaled Decepticon Base diorama WIP
Posted: Fri Aug 07, 2015 10:21 am'sup everyone? I have been living with my Ark diorama for a few months now and of course all the while I have been hatching my plans for the Decepticon base...
I've been working on this project for a few weeks now, so I figured I would start an official WIP thread.
My idea for this project was to make the base out of the telescoping tower that Decepticon's used to enter/exit the Nemesis from the G1 cartoon.
The tower will have 2 levels. The top level will have the "draw bridge" door and there will an elevator to get to the bottom level.
At this point it'll probably bee about 5ft tall when complete and will take up a 2ft by 4ft foot print.
Here it is so far...
I've been working on this project for a few weeks now, so I figured I would start an official WIP thread.
My idea for this project was to make the base out of the telescoping tower that Decepticon's used to enter/exit the Nemesis from the G1 cartoon.
The tower will have 2 levels. The top level will have the "draw bridge" door and there will an elevator to get to the bottom level.
At this point it'll probably bee about 5ft tall when complete and will take up a 2ft by 4ft foot print.
Here it is so far...
Looking forward to taking you all along!
