Page 1 of 1

DOTM Galvatron

PostPosted: Mon Sep 11, 2017 8:47 am
by NeonPrime
Yep...yet another Galvatron (it's an obsession). This time it's my take on a DOTM Galvatron. I thought it'd be cool to combine the corpses of Megatron & Shockwave. Below is a pic of this version with the rest of the Galvatrons I've done (so far).

Re: DOTM Galvatron

PostPosted: Sat Sep 16, 2017 10:34 am
by ZeldaTheSwordsman
Nice idea and work. But it looks like no. 3 needs some Elmer's and a shot of clearcoat on one of his stickers.

Re: DOTM Galvatron

PostPosted: Sun Sep 17, 2017 1:01 am
by TulioDude
Where do you got the head?

Re: DOTM Galvatron

PostPosted: Sun Sep 17, 2017 5:10 pm
by NeonPrime
TulioDude wrote:Where do you got the head?


Igot the head from the 2007 movie voyager Megatron. It was a great mold and luckily it just popped off and fit DOTM Shockwave perfectly. The only mod I had to do was remove the rubber hose connector that was was close to the head. It still fit and transformed before the mod but the head would sometimes pop off due to the lack of clearance. Now it's smooth conversion from robot to vehicle.

Re: DOTM Galvatron

PostPosted: Sun Sep 17, 2017 5:17 pm
by NeonPrime
ZeldaTheSwordsman wrote:Nice idea and work. But it looks like no. 3 needs some Elmer's and a shot of clearcoat on one of his stickers.

Thanks! I usually use two sided tape for my stickers and it holds pretty good. These stickers were done in 2014 as a mock up and placed on a non painted version just to see how they would look and if the size was accurate. When I finally got around to painting the figure this past April I had to peel them off and was out of tape hence the curling. Eventually I'll get more and secure it. I kinda want to wait until I finish stickers for the other versions first so I can knock em out all at once. I did apply non yellowing clear packing tape for the clear coat...the camera just doesn't pick it up.