PotP Animal Sidekicks (3D-Printed Heads for PotP Fists)
Posted: Tue Aug 28, 2018 9:44 amI prefer to leave my figures in individual robot mode rather than as combiners. But I'm not crazy about how the combiner fists look as accessories.
Then, I saw someone else post pictures of a combiner fist posing as an animal sidekick, and the thought popped in my head that it would look even better with an actual animal head.
So I whipped up some renders and printed them out. The 5mm ports were a little tight and required some scraping to get them to fit, but this was the result of the experiment.
I'm working on a few more, but I wanted to share the first three.
Hope you think they are fun...or at least funny!
Then, I saw someone else post pictures of a combiner fist posing as an animal sidekick, and the thought popped in my head that it would look even better with an actual animal head.
So I whipped up some renders and printed them out. The 5mm ports were a little tight and required some scraping to get them to fit, but this was the result of the experiment.
I'm working on a few more, but I wanted to share the first three.
Hope you think they are fun...or at least funny!