The Energon Pub

I've always wanted a nice well-scaled Slipstream for my chug shelf, and so I grabbed a Starscream from Ross and did a thing.










Head is from Shapeways - https://www.shapeways.com/product/HTKF4 ... arketplace
The nullrays are from Go Better Studio - https://www.tfsafari.com/products/pre-o ... 9209726065
And the hands are from an old Generations Perceptor.

Very nice work. I don't think the hands and head were needed per se, but it's not like they hurt. About the only thing that could make this better than it is already is if you could get reproductions of the transparent parts cast in transparent blue plastic.

Not bad at all! I personally don't much care for just using male molds as females, but the head and hands combined with your knack for posing really do help. Also that's a crisp paintjob!