The Energon Pub

this is my first transformers repaint. i have to work in vegas for a week, but when i get back and do some touch-ups, and i'll take pics in vehicle mode too, as well as some side by sides with RiD scourge(s).
i went with the scourge scheme instead of the nemesis prime scheme (which has tan), so lemme know what you think.
i used krylon fusion paints and a lot of patience.
cheers:


[/img]

Looks pretty awesome

and Scourge>>>>Nemesis Prime

He needs a sword though

he stole rid scourge's.. fits perfectly, looks great.. more pics soon

Handsome!

Does the Krylon FUsion stuff work good? LIke, does it chip alot or anything?

it takes some getting used to.. use as much i would definetly say painters tape as you can when using multiple paints. and understand to use several coats and light spraying. after doing this one, i would also say to cover the joints and pegs that go into joints. or be prepared for alot of sanding. the only problem i had with this paint was using it with a brush ontop of a different coat. (scourge's face mask is the issue).. the paint clumped a bit and lost some of it's integritey. this could have been avoided by taping that section off. but besides using it out of the can (spraying wise), i had good luck using it with brushes in small amounts, also doing multiple coats.
hope that helps.
but i really dig the paint, and it stays on very well.

Can we see a picture with the sword in hand pllleeassee?

gotta wait till i get back home on friday.. sorry

looking good, very nice man that is an amasing repaint!

decepticonjon wrote:gotta wait till i get back home on friday.. sorry

No worries

I can wait...but only because Friday isn't to far away

Looking very nice. Great work man. ^^