PCC G1 Scattershot
Posted: Sat Apr 23, 2011 2:33 pmOk, so here is the last of the 5 Technobots I am doing for the PCC/HFTD Computron. I know, I know...he is lacking his familiar "bulge". 
Also, I know the cockpit windows aren't as clean as others could make them. I tried using tape cut to fit to guide me, but each piece was too small and would just come off. I also want to paint the nosecone white, but I know that it is very hard to get paint to stick well and look nice on rubber nosecones. I've tried this before! Any suggestions or thoughts would be appreciated! I'm including a picture of my modification to include the female portion of PCC drones' connections into his feet for Computron as well. Next is going to be getting them all to connect! (That should be fun....)
Thanks!
-Mike
Also, I know the cockpit windows aren't as clean as others could make them. I tried using tape cut to fit to guide me, but each piece was too small and would just come off. I also want to paint the nosecone white, but I know that it is very hard to get paint to stick well and look nice on rubber nosecones. I've tried this before! Any suggestions or thoughts would be appreciated! I'm including a picture of my modification to include the female portion of PCC drones' connections into his feet for Computron as well. Next is going to be getting them all to connect! (That should be fun....)Thanks!
-Mike