The Energon Pub

Here goes, i finally made him on the weekend. didnt take to long, but just a ton of busted fingers. Anyway he is complete, i just have to clean up and sand a tiny bit then finish painting him.
What ya think

First off, welcome to the greatest site on the internet, Secondly, HOLY SCREAMING MOTHER OF PRIMUS! That's great! You could have a little buisiness going for yourself with headmaster minicons of that quality!

Um, Ok. Dont know how to reply so.

Thanks

BeastProwl wrote:First off, welcome to the greatest site on the internet, Secondly, HOLY SCREAMING MOTHER OF PRIMUS! That's great! You could have a little buisiness going for yourself with headmaster minicons of that quality!

JAKA wrote:Um, Ok. Dont know how to reply so.

Thanks

BeastProwl wrote:First off, welcome to the greatest site on the internet, Secondly, HOLY SCREAMING MOTHER OF PRIMUS! That's great! You could have a little buisiness going for yourself with headmaster minicons of that quality!

It's easy, just hit "Quote"

Pretty good job. How long did it take you to do it?

Not very long, only 2 days, as i had to wait for putty stuff to harden, then sand, apply again where needed and sand, then done.
I knew what i wanted to do, laid out the steps & peices and went to work, crazy glue in place to fit then went for it. Not all that hard to do, if i had the parts again, ill do another one. Getting for parts ordered now. Need Minicon and superion head.
and smaller parts for minor diferent look to each.

Cougartracks wrote:Pretty good job. How long did it take you to do it?

How Much would a Custom like this Sell For, just curious???
And is there a for sale section on Here??

Thanks
Don

BeastProwl wrote:

JAKA wrote:Um, Ok. Dont know how to reply so.

Thanks

BeastProwl wrote:First off, welcome to the greatest site on the internet, Secondly, HOLY SCREAMING MOTHER OF PRIMUS! That's great! You could have a little buisiness going for yourself with headmaster minicons of that quality!

It's easy, just hit "Quote"