Page 1 of 1

TFP Autobots

PostPosted: Sun Apr 07, 2013 12:11 pm
by Skyfire77
I've been working on these for a while now, but now I've gotten all my pictures taken, and it's time to share!

Arcee
ImageImageImage
ImageImageImage
Image

Testors paint was used to give Arcee a more screen-accurate appearance. I also chopped down her original blaster and added a ball joint. Finally, I added fakebusker83's Blades.

Bulkhead
ImageImageImageImage
ImageImageImageImageImageImage

Again, detailed with Testors. I also disassembled his weapon, which now fits into a hole I drilled into his fist. A C.L. GR is substituting for his blaster.

Bumblebee
ImageImageImageImage
ImageImageImage

No modifications to Bee, just paint.

Cliffjumper
ImageImageImageImage
ImageImageImageImage

A bit of paint, Reprolabels, and fakebuster's blasters.

Optimus Prime
ImageImageImageImage
ImageImageImageImage
ImageImageImageImageImageImageImageImage

I did a lot of work on OP. Repainted, Bare Metal Foil used for his vehicle mode chrome, and Reprolabels. I also purchased Fakebuster's blades and smokestacks, Lorddragonmaster's "Celestial Sword", and Dr. Wu's blasters.

Ratchet
ImageImageImage
ImageImage

I did a little bit of painting on his feet and wheels, everything is Reprolabels

Wheeljack
ImageImageImage
ImageImageImage
ImageImageImage

Repainted his swords, forearms, hands, and thighs. Added Reprolabels and Fakebuster's blasters and grenade.

Re: TFP Autobots

PostPosted: Sun Apr 14, 2013 8:52 am
by Autobot Strider
Wow that's some great work man! Everything looks very top-notch. I am so tempted to get one of those Star Sabers for my FE Prime...

I'm particularly interested in how you drilled the hole in Bulkhead's fist... would it be possible to see some pics of the mace end that plugs into the hole, and the hole itself? What size of drill bit did you use?

Thanks!

Re: TFP Autobots

PostPosted: Sun Apr 14, 2013 9:29 am
by Skyfire77
The mace:
Image

The fist:
Image

Basically I just took Bulk's weapon apart, then used my Dremel to remove the gray piece the mace attaches to, exposing a 2mm pin. I used a 5/64ths drill bit, then used some filler putty to get the hole sized.

Re: TFP Autobots

PostPosted: Sun Apr 14, 2013 10:07 am
by Doubledealer93
Skyfire77 wrote:The mace:
Image

The fist:
Image

Basically I just took Bulk's weapon apart, then used my Dremel to remove the gray piece the mace attaches to, exposing a 2mm pin. I used a 5/64ths drill bit, then used some filler putty to get the hole sized.


how well does that hold in?

Re: TFP Autobots

PostPosted: Sun Apr 14, 2013 3:22 pm
by Skyfire77
To be honest, I need to build up the pin a bit. It's loose, so any poses with the mace pointed down won't work. Otherwise it's fine.

Re: TFP Autobots

PostPosted: Sun Apr 14, 2013 7:46 pm
by Autobot Strider
Awesome, that gives me plenty to work with. Thank you so much!