The Energon Pub

This is one was a little more extensive, though I'm fairly happy with it.
Except for the right leg. Anyone have a tip on how to tighten the pin joint? It keeps flopping all over the place.

Dirtied it up, essentially, with a black then gold wash. Made the claws and fangs stick out with black and silver, added black to the wings and tried bringing out all the molded details in the figure with gold, black or silver.

I can't believe I hadn't picked this one up yet, the engineering is astonishingly clever!

Very nice work! He looks much better, so many of his details are brought out now, great job!
Not sure on tightening the knee pin, but maybe if you tried using a toothpick to drop a very tiny bit of Future floor polish into the pin hole in the side of the knee with the leg held horizontally so it could run down into it a bit as you worked the leg back and forth a little?