Ratchet plate problems
Posted: Tue Oct 16, 2007 5:46 amhi, for any ratchet owners, is it normal for the plates on the back of the thighs to fall off occasionally?
The Energon Pub
SEIBERTRON - Your Planet For Everything Transformers
https://www.seibertron.com/energonpub/
Ratchet plate problems
https://www.seibertron.com/energonpub/viewtopic.php?f=4&t=20792
Page 1 of 1
Posted: Tue Oct 16, 2007 5:46 amPosted: Tue Oct 16, 2007 5:51 amYes. I had this problem and have met many others who did as well. To solve this, put an extremely small spot of superglue on the edge of the peg AFTER you slide it through the hole on the thigh. Then you can put the rail back on and hold it tight for at least 30 seconds. If you did it right and didn't overdue the superglue it should still rotate as well as hold together. Good luck!
plate
Posted: Tue Oct 16, 2007 7:27 amThanks, my Rescue Ratchet did this the minute I took it out of the box. So now I know a dab of glue, and its good as new.