Page 1 of 1
Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 2:44 pmby Alex Jones
I am having a lot of difficulty trying to lock in Recon Ironhide's hip with the peg. the only way I got in the last time was through excessive force but I was wondering if this is typcial with the figure I got or if there is something I am not doing right.
thanks in advance.
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 3:01 pmby Blurrz
Which Hip Pegs? If you're talking about 2 pegs that are sticking out, than that's just how it's supposed to be with that figure.
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 3:04 pmby Alex Jones
the one gray peg with a silver cap on.
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 3:34 pmby Blurrz
I've got two Ironhides.. not with me at the moment, so I've got no clue what's going on, XD. Nevermind me then..
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 4:43 pmby Jelze Bunnycat
Lousy_Autobot_Lover wrote:the one gray peg with a silver cap on.
If you're talking about the connection between the hips and the torso, all figures have that, and are supposed to be like that. The parts connect at an angle.
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sat Jan 09, 2010 6:18 pmby Evil_the_Nub
Mine was really hard to get in too, so I think they're all like that.
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sun Jan 10, 2010 7:42 amby Mykltron
Mine (original 07) doesn't have any problems. I can't see how it's possible to do something wrong with that part of the transformation. Is the peg just too tight for the hole?
Re: Trouble With Recon Ironhide's Hip Peg
Posted:
Sun Jan 10, 2010 11:23 amby Alex Jones
it does not seem aligned if that makes sense. Like i am trying to get it in at angle but the angle is not alinged where the peg can get inside the hole.