Page 1 of 1
device label blaster
Posted:
Sun Jun 13, 2010 8:17 amby Doubledealer93
i dont know if any one has this guy yet, but i was wondering how big he would be. cus if he is the same size as the DL soundwave then i will get him. i want blaster to fit in with my classics autobots.
Re: device label blaster
Posted:
Sun Jun 13, 2010 8:26 amby Diem
Doubledealer25 wrote:i dont know if any one has this guy yet, but i was wondering how big he would be. cus if he is the same size as the DL soundwave then i will get him. i want blaster to fit in with my classics autobots.
No one has this guy yet but he's bigger than DL Soundwave. He appears closer in size to G1 Soundwave.
Re: device label blaster
Posted:
Sun Jun 13, 2010 8:47 amby Doubledealer93
ok thanks man!
i will wait to get him to see some size comparisons.
Re: device label blaster
Posted:
Sun Jun 13, 2010 8:50 amby Mykltron
I'd be interested if he was the same size as ML SW too. No such luck.
Re: device label blaster
Posted:
Sun Jun 13, 2010 9:16 amby Gauntlet101010
What's with decrying his size? He haven't even seen a picture of him with ML Soundwave.
I don't think he'll wind up too much taller than ML Soundwave. While ML SW can't hold G1 cassettes the actual size of his door, including the lower hinge, seens just about right when you look at DL Blaster. Meanwhile G1 SW seems to have a much larger frame overall. Moreover, the buttons on Blaster don't seem as large as ML SW (probably since they aren't functional). That tapedeck is HUGE on Blaster.
Re: device label blaster
Posted:
Sun Jun 13, 2010 10:33 amby Mkall
I suspect he'll be about the same height, but slightly wider to accomodate the tape. If you take a look at the cassette-holding image, you'll see that the cassette basically takes up the entire body, whereas G1 soundwave, there was a lot of bodyspace left over for other gimmicks.
By my very rough calculations, using Blaster's chest as a 3.5cm in height (the width of a cassette) I estimate him to be about 15 cm, head to toe. ML Soundwave measures in that tall too, so they should be more or less in scale with eachother.
Re: device label blaster
Posted:
Mon Jun 14, 2010 4:14 amby Mykltron
Mkall wrote:I suspect he'll be about the same height, but slightly wider to accomodate the tape. If you take a look at the cassette-holding image, you'll see that the cassette basically takes up the entire body, whereas G1 soundwave, there was a lot of bodyspace left over for other gimmicks.
By my very rough calculations, using Blaster's chest as a 3.5cm in height (the width of a cassette) I estimate him to be about 15 cm, head to toe. ML Soundwave measures in that tall too, so they should be more or less in scale with eachother.
Me: HAZZAH!
Wallet: grrr