WST Flamethrower hip Stickers.
Posted: Wed Jun 06, 2007 8:42 amRemoving WST Flamethrower’s Clear Hip Pieces
When removing Flamethrower’s hip pieces to apply the factory stickers in the Reprolabels set, it is almost impossible to pry them out like on Desert Warrior.
The best and easiest way is to push up the 3 prongs on the inside of the leg so you can avoid digging into the leg with a small tool to pop it out, like I did.
You can see the 3 holes on the outside and thus you can see where you need to push up from the inside.
After you do this you must apply the label to the screw section so that when you replace the cap it will not move around.
When removing Flamethrower’s hip pieces to apply the factory stickers in the Reprolabels set, it is almost impossible to pry them out like on Desert Warrior.
The best and easiest way is to push up the 3 prongs on the inside of the leg so you can avoid digging into the leg with a small tool to pop it out, like I did.
You can see the 3 holes on the outside and thus you can see where you need to push up from the inside.
After you do this you must apply the label to the screw section so that when you replace the cap it will not move around.