The Energon Pub

So i was thinking what if you got a bumblebee off ebay repaint it add another head to his body, get some trans am model kit decals, then add an Autobot or Decpection logo and there you have a new custom transformer.









Tip: easy way to cut threw plastic is by heating up a exacto knife till blade turns red and then you cut threw plastic like butter.

DARKTHUNDER wrote:So i was thinking what if you got a bumblebee off ebay repaint it add another head to his body, get some trans am model kit decals, then add an Autobot or Decpection logo and there you have a new custom transformer.









Tip: easy way to cut threw plastic is by heating up a exacto knife till blade turns red and then you cut threw plastic like butter.

how to heat the knife??i mean using what??im a newbie here,n i lack the proper tool for a kitbash..

gas stove, a lighter etc. just heat up the blade till it turns red and then cut whatever u need to just be really careful.

"through", not "threw".

Thanks professor

I think this would be an awesome idea. I build model cars and dont see this being that difficult. However instead of using a hot blade got to your local hobby store and ask about getting a razor saw. This will work MUCH better than a hot blade and is much safer also.

do I have to get the Bumblebee toy from ebay?

oh, and I suspect the best way to remove the head from the toy would be by using 3 or 4 tons of high explosive, that will guarantee it'll be completely removed. of failing that, get a dinosaur to bite it.

well i suggested an ebay bumblebee cause if you mess up it wouldnt be that bad of a loss and yes the explosive to remove the head was a great idea.