The Energon Pub

Sorry if this is a stupid question, but my Leader Ironhide's right shoulder is quite a bit looser than the left. Anyways I was wondering if I could use the super glue trick on his shoulder, or is this unrecommended for the pin joint?

Thanks for your help.

You can do it for pin joints but you'll need to move the joint every few seconds for around half an hour to prevent it locking.

The right shoulder on mine is looser than the left too, but not so much that he can't hold a pose. Did you try tightening the screw?

I have the same problem too, I think its the same for all IH figures. Bad Hasbro QC as usual. For me I'm not gg to do anything about it though as like the above poster said, poses are still pretty doable.

Thanks for the help. If it gets too loose I'll know I can use the super glue trick. Thanks for the help.

I don't remember having this issue with mine. The panel on his left cannon doesn't stay firmly closed and that annoys me.

My Ironhide has the same loose panel over his right cannon. Although as peaugh has shown that seems to be normal.