The Energon Pub

Just a quick question can the nose cones on the g1 seekers be replaced ?.

With a junker rubber cone that is.

Just let it soak in some warm water for a while, that will soften it up and you should be able to just pull it off and replace it with one from another seeker as fenrir suggested.

Another case of 'chewed nose' syndrome? Happened to one of mine. I never did find out who the culprit was.

Burn wrote:Just let it soak in some warm water for a while, that will soften it up and you should be able to just pull it off and replace it with one from another seeker as fenrir suggested.

fenrir72 wrote:With a junker rubber cone that is.

Cheers guys , yeah i meant with another G1 nose cone.

Banjo-Tron wrote:Another case of 'chewed nose' syndrome? Happened to one of mine. I never did find out who the culprit was.

Yep sadly skywarp has a couple of small dint's with any luck i'll find a junker in good condition.

You can just disassemble the front of the jet and put a new cone on without anything fancy.

Counterpunch wrote:You can just disassemble the front of the jet and put a new cone on without anything fancy.

cheers CP i never actually realised there was a screw on the side

Autobot Genocide wrote:

Counterpunch wrote:You can just disassemble the front of the jet and put a new cone on without anything fancy.

cheers CP i never actually realised there was a screw on the side

Thanks from over here too.