Question about ratchet joints on FOC Bruticus
Posted: Wed Mar 06, 2013 11:10 pmGreetings!!
Not sure where to post this question, but here goes.
My FOC retail Bruticus, specifically Blast-Off, has been suffering from a squeeky loose joint in his combiner connector piece. All my other figures are fine and 'racthet-y', but Blast-Off is the odd man out.
Any advice on how to correct this? Is it even possible to correct this issue? Any remedies involving floor wax? I have tried to disassemble the joint, to no avail
.
I am in no way a customizer and have little to no experience fixing figures. Detailed instructions will help tremendously and be greatly appreciated.
Thanks for the help.
Not sure where to post this question, but here goes.
My FOC retail Bruticus, specifically Blast-Off, has been suffering from a squeeky loose joint in his combiner connector piece. All my other figures are fine and 'racthet-y', but Blast-Off is the odd man out.
Any advice on how to correct this? Is it even possible to correct this issue? Any remedies involving floor wax? I have tried to disassemble the joint, to no avail
. I am in no way a customizer and have little to no experience fixing figures. Detailed instructions will help tremendously and be greatly appreciated.
Thanks for the help.