Tramp wrote:Well, I just checked about 40 pages of screencaptiures from the movie, and PF is correct about the green and brown interior for Hot rod. Regardless, it is still a poor choice of color. Black, or even all brown, would look ten times better. Whoever did his interior design had awful taste.
Interesting use of the stock wings...Good work!TFmaster wrote:I think we're do for some kinda update.
This is my Current WIP.
Enjoy.
TFM
James28210 wrote:Interesting use of the stock wings...Good work!TFmaster wrote:I think we're do for some kinda update.
This is my Current WIP.
Enjoy.
TFM
Would you be willing to share the tricks to popping out the pins (as in which direction). I THINK the arm pins anchor on the flush side. Also, cannot figure out which way the front cockpit pin pushes out and the arm/shoulder pivot hinge pin looks tricky.
Also, I am tempted to pull those pins that hold the rear wing to the thruster and the main wing pin but I see no way to get a grip on them to pull.
I hope to have all 8 seekers done by spring.
Pyroclasm wrote:This is concerning the Classics tank Megs from the vs. two-pack.
Not sure if this problem was unique to the Megatron I pulled:
According to the tranformation instructions, his feet are not supposed to protrude in alt mode, but with the feet attached like the art on the box, they won't fold in as instructed.
TFmaster wrote:I think we're do for some kinda update.
This is my Current WIP.
Enjoy.
From my experience, the rough end is usually flush or slightly raised from the surface of the hole while the smooth end in recessed slightly.James28210 wrote:Yes I did read the guide but I am having a hard time distinguishing rough holes from smooth holes.
Thanks and looking forward to your version of Thrust.
Registered users: -Crossfire-, Bing [Bot], bluecatcinema, Google [Bot], Google Adsense [Bot], Majestic-12 [Bot]