The Energon Pub

[Doubledealer93]

very time i try to attach a sig it says that the picmessage is not allowed. am i doing it wrong? is the pic too big? i dont know so could some one help me with this?

[Mkall]

Are you trying to link to an image from your hard drive, or an image on the internet.

You first off need to upload your image to a photohosting site (I use http://www.photobucket.com), then link to it in your sig

Code: Select all

[img]image.site.com/your/image/location.jpg[/img]

[Firebird]

Also make sure that the picture is within the set limits for the boards. Just select the properties of the picture that you are using and be sure that it fits the dimensions.

Cyber Bishop set up a sticky with all the requirements and sizes here.
viewtopic.php?f=14&t=369

[Doubledealer93]

Are you trying to link to an image from your hard drive, or an image on the internet.

You first off need to upload your image to a photohosting site (I use http://www.photobucket.com), then link to it in your sig

Code: Select all

[img]image.site.com/your/image/location.jpg[/img]

it is from my hard drive.

[Mkall]

Are you trying to link to an image from your hard drive, or an image on the internet.

You first off need to upload your image to a photohosting site (I use http://www.photobucket.com), then link to it in your sig

Code: Select all

[img]image.site.com/your/image/location.jpg[/img]

it is from my hard drive.

Then that would explain it. You must first upload it to an image hosting site, such as http://www.photobucket.com. Once it's been uploaded you can then link to it by use of the img tags in the example above.