The Energon Pub

[Ash]

There is a Problem In My Blackout Everytime I spin His rotors The Rotors fall off, Even when it is not spinning it falls off is this some kind of Gimmick Hasbro installed to make the stupid autobots look better?

[Flashback]

yikes! Never had that problem, might be worth going back to replace it. The rotors on mine are so tight it feels like I'm gonna break it if I try to remove them!

[Optimus Schtool]

Don't feel bad dude--mine pop off too--just snap them back on--no worries..

[Ash]

yeah but these are a pain in the neck. I cant even Pick it up. shall i glue them?

[starhorse]

I wouldn't glue them, since you need to fold them for robot mode transformation. Like mentioned above, you might consider taking it back for replacement. I certainly would if I were in that same situation.

[SpacerAM2]

They are meant to pop out. You can put them back easily. Don't glue them it's a bad idea.

[Optimus_Prowl]

Have any of your Blackouts have their automorph mess up. Mine kinda did but i managed to move it back into place.

[Sonic Wing]

dudeeeee sad for u, that doesnt happen to me...

[Optimus Schtool]

Yeah--Blackout doesn't hold together too well in his alt mode--the sides won't hold & his legs always want to fall down. I usually just display him in his robot mode most of the time.