The Energon Pub

News Credits: 33 · Wed Jul 11, 2012 6:02 am

Just a quick question can the nose cones on the g1 seekers be replaced ?.

News Credits: 60 · Wed Jul 11, 2012 6:24 am

With a junker rubber cone that is.

News Credits: 226 · Wed Jul 11, 2012 7:02 am

Just let it soak in some warm water for a while, that will soften it up and you should be able to just pull it off and replace it with one from another seeker as fenrir suggested.

News Credits: 2 · Wed Jul 11, 2012 7:55 am

Another case of 'chewed nose' syndrome? Happened to one of mine. I never did find out who the culprit was.

News Credits: 33 · Wed Jul 11, 2012 9:18 am

Burn wrote:Just let it soak in some warm water for a while, that will soften it up and you should be able to just pull it off and replace it with one from another seeker as fenrir suggested.

fenrir72 wrote:With a junker rubber cone that is.

Cheers guys , yeah i meant with another G1 nose cone.

Banjo-Tron wrote:Another case of 'chewed nose' syndrome? Happened to one of mine. I never did find out who the culprit was.

Yep sadly skywarp has a couple of small dint's :-(

with any luck i'll find a junker in good condition.

News Credits: 129 · Wed Jul 11, 2012 9:41 am

You can just disassemble the front of the jet and put a new cone on without anything fancy.

News Credits: 33 · Wed Jul 11, 2012 2:35 pm

Counterpunch wrote:You can just disassemble the front of the jet and put a new cone on without anything fancy.

cheers CP i never actually realised there was a screw on the side :oops:

News Credits: 1 · Wed Jul 11, 2012 2:47 pm

Autobot Genocide wrote:
Counterpunch wrote:You can just disassemble the front of the jet and put a new cone on without anything fancy.

cheers CP i never actually realised there was a screw on the side

Thanks from over here too.