The Energon Pub

Anybody know where I can get instructions for alternator Skids? I got a custom version of him but it did not come with instructions.

until I scan mine, here is the sequence:

Transformation to Robot Mode:

1. Lift the hood and remove the car engine. Flip the gun barrel up and set it aside for now.
2. Swing the rear bumper down.
3. Lift the rear section of the vehicle up on the hinge at the midpoint.
4. Fold that section forward on the hinge, then swing the back section (with the rear hatch door) down.
5. At the rear of the vehicle, fold down the robot feet and flip out the heel pieces.
6. Fold down the rear seats.
7. Open the two front doors.
8. Slide the two front seats back and then fold them down.
9. Pull the section with the dashboard and the top of the vehicle back a bit.
10. Unfold the front section and extend it upwards.
11. Rotate the dashboard section around.
12. Roate the front doors so they are horizontal.
13. Pull out each robot arm from under the hood to the sides.
14. Swing the robot head up.
15. Rotate the doors back to their original position.
16. Push the hood section back down, the black platform the robot head rests on has a notch that the tab at the center of the hood section connects to.
17. Swing the two grey pieces from the back section down, connecting them to the chest piece in the two holes on either side of the head.
18. Split the legs and extend each out.
19. Place the gun in Skids' hand.

Sweeeet...thanks

your welcome...I will scan mine instructions tomorrow morning.