The Energon Pub

News Credits: 5 · by **decepticonjon** » Sat May 05, 2007 9:26 pm

this is my first transformers repaint. i have to work in vegas for a week, but when i get back and do some touch-ups, and i'll take pics in vehicle mode too, as well as some side by sides with RiD scourge(s).
i went with the scourge scheme instead of the nemesis prime scheme (which has tan), so lemme know what you think.
i used krylon fusion paints and a lot of patience.
cheers:

[/img]

News Credits: 1 · by **Redimus** » Sat May 05, 2007 9:32 pm

looks good.

News Credits: 1 · by **Venomous Prime** » Sat May 05, 2007 11:50 pm

Looks pretty awesome

and Scourge>>>>Nemesis Prime

He needs a sword though

News Credits: 5 · by **decepticonjon** » Sun May 06, 2007 1:00 am

he stole rid scourge's.. fits perfectly, looks great.. more pics soon

News Credits: 5 · by **decepticonjon** » Sun May 06, 2007 1:20 am

by **Tom_Servo** » Sun May 06, 2007 10:00 am

Handsome!

by **O. Prime** » Sun May 06, 2007 6:58 pm

Does the Krylon FUsion stuff work good? LIke, does it chip alot or anything?

News Credits: 5 · by **decepticonjon** » Mon May 07, 2007 12:07 am

it takes some getting used to.. use as much i would definetly say painters tape as you can when using multiple paints. and understand to use several coats and light spraying. after doing this one, i would also say to cover the joints and pegs that go into joints. or be prepared for alot of sanding. the only problem i had with this paint was using it with a brush ontop of a different coat. (scourge's face mask is the issue).. the paint clumped a bit and lost some of it's integritey. this could have been avoided by taping that section off. but besides using it out of the can (spraying wise), i had good luck using it with brushes in small amounts, also doing multiple coats.
hope that helps.
but i really dig the paint, and it stays on very well.