The Energon Pub

Website · by **hippymule** » Sun May 17, 2009 11:07 am

i want to make a figure using barricade called riot police barricade. i was wandering if you need an electric dremel or just a hobby knife to make bullet holes, could i just use a drill? also i need police stickers if you know were i might be able to find one also i need an edesive(glue) becouse i want to add spikes to the front and such. piant whys i use testers enamil witch comes with basic colors with gold and silver but the damn piant wont come of the brushes!

by **Valandar** » Thu May 21, 2009 3:18 am

You can go to a local hoby store and get what's called a "pin vice", and get tiny drill bits for it. If you want the bullet holes to be of human caliber, a #80 size bit would be appropriate for most hand-held weapons up to .50 caliber. A 20mm non-explosive round would be a #74, and a 30mm non-explosive round would be a #66. You could actually get away with drill bits twice that size (up to #70 for human sidearms, #56 for a 20mm, and a #51 for 30mm) to represent distortion from the impact widening the hole. And as if it wasn't obvious, the smaller the number means the bigger the drill bit.

One thing to remember to do is to "chip" the paint around the holes, by the way - I've seen too many "bullet holes" that don't look right because they forgot that.

Website · by **hippymule** » Fri May 22, 2009 5:34 pm

Valandar wrote:You can go to a local hoby store and get what's called a "pin vice", and get tiny drill bits for it. If you want the bullet holes to be of human caliber, a #80 size bit would be appropriate for most hand-held weapons up to .50 caliber. A 20mm non-explosive round would be a #74, and a 30mm non-explosive round would be a #66. You could actually get away with drill bits twice that size (up to #70 for human sidearms, #56 for a 20mm, and a #51 for 30mm) to represent distortion from the impact widening the hole. And as if it wasn't obvious, the smaller the number means the bigger the drill bit.

One thing to remember to do is to "chip" the paint around the holes, by the way - I've seen too many "bullet holes" that don't look right because they forgot that.

any ideas for piant or edhesives(gluey substince)

News Credits: 9 · by **Mykltron** » Sun May 24, 2009 6:32 pm

hippymule wrote:also i need police stickers if you know were i might be able to find one also i need an edesive(glue) becouse i want to add spikes to the front and such. piant whys i use testers enamil witch comes with basic colors with gold and silver but the damn piant wont come of the brushes!

Police stickers: look into making your own decals. I don't know anything about it but I know some people around here print their own.

Glue: decent brand superglue normally works, especially if you rough both surfaces slightly with sandpaper or make lots of tiny criss-cross gashes with a scalpel. Or epoxy resin: two substances that you mix together to make the glue.

Paint: try washing it off with white spirit and liquid soap, though as it's already set you won't get it off. Try using water-based acryllic. You can wash it off with water and a little soap and it doesn't dry in the pot like enamel paints can. Don't use the same brush for acryllic and enamel paints as it ruins the brush. Games Workshop make good paints but I just got some Reeves paints from an art shop and the quality is as good but it's SOOOO much cheaper. It's thick like toothepaste, you need to add some water.