I wish I had taken a pic after I removed the paint w/ rubbing alcohol. There is so much detail to this mold that is lost to the factory paint.
The head swap was actually kinda complicated. FAB SS/RJ's head is on a ball joint where as SS is just a peg. I used the existing ball joint and small square base of plastic. Then chopped off the peg and dremeled out the size of the square base on voy. SS. I then used some 2-ton epoxy to glue the head down.
Finally a simple paint job. A black wash followed by silver dry brushing, and some gold detailing. I also dotted the "sculpted eyes" red and painted that little bar that crosses over them silver. Had to use the itty bitty brush for that
