The Energon Pub

Like Omegatron10 on Facebook · by **Omegatron10** » Wed May 09, 2012 10:54 am

Hi,
My dinobot sludge has very loose joints and I was wandering would it be possible to repair them? basically its his legs the joints are very loose and he falls over with ease.

Any help would be much appreciated

by **MGrotusque** » Wed May 09, 2012 11:37 pm

I have the same problem with a couple of mine. I've tried tightening those screws in the knees to the point of striping but to no avail.

I just kept hunting and buying till i FINALLY found a tight one that didn't topple. The only other alternative to buying 4 of them like i did is maybe wedge a piece of paper in there or something to stiffin it up. It's an easy fix and invisible and that of which also doesn't require modifying/ruining a G1 figure. Insofar as useing nail polish or whatever like you would to repair a loose ball joint on a modern figure. Which in my opinion ruins the value of a G1 figure.

I continued buying them cause i wanted an"unassisted" minty Sludge that could stand on his own.

Hope that helps.....maybe.

The Energon Pub

Repairing Transformers dinobot Sludge:

Repairing Transformers dinobot Sludge:

Re: Repairing Transformers dinobot Sludge:

Who is online

Forums

Transformers News

Transformers and More @ The Seibertron Store

Featured Products on Amazon.com

The Ultimate Caption Contest