The Energon Pub

by **Spotter5** » Tue Aug 23, 2016 4:10 pm

Sorry if this has been asked before,been searching the forums for about 10 mins but couldn't find anything.

So is there a fix for his wobbly head? its a little bit annoying, especially as my Galvatron and Brainstorm heads are ok (not actually tried any other heads on Scourge yet though :-?

)

by **Optimum Supreme** » Tue Aug 23, 2016 5:17 pm

There's clearly a problem with the design of the socket on the robot body. If you put in vehicle mode and plug the head in on top for the goofy robot head in vehicle mode homage, it plugs in just fine there.

Also seems to fit okay on other figures' bodies.

Mine's actually not super bad but still not how it should be.

News Credits: 90 · by **Tyrannacon** » Fri Aug 26, 2016 8:43 am

This thread and specific post covers one solution at least with stuffing a business card colored blue into the hole to "tighten" it up. I have the same problem with Scourge myself and frankly the whole "Titan Master" is relatively loose overall. My Nucleon for Galvatron has no problems actually and all the joints are tight. I've been very careful with both though in any case due to horror stories I've heard about it.

by **Optimum Supreme** » Thu Sep 01, 2016 6:06 pm

My Hardhead is a little loose, looser than my Scourge, anyway, but the bobble head award goes to the Highbrow I picked up at Walmart today. I've seen actual bobble heads that don't jiggle around like this one...