Come and get 'em, I got yer Allspark Power Stockade mods right here, fresh outta my brain!
I love Stockade, but as my TF sickness mandates, I had to mod him. Had to. I was getting DTs looking at him factory-original. So I came up with two quick easy mods for the big lug to improve his articulation and poseability.
First, his knees. Trim away some of the molded detail on the back of his knee, immediately above the cylindrical joint:
- P1000911.JPG (209.37 KiB) Viewed 590 times
You can go further than I went and get more knee flex, but you might start to lose strength in the part. As shown, this mod lets him get into deeper crouching poses:
- P1000918.JPG (102.75 KiB) Viewed 588 times
OK, next up, the windshield kibble on his forearms. Easy-peasy. Remove the windshield halves, and trim away a bit of the little rectangle of plastic shown here:
- P1000913.JPG (40.09 KiB) Viewed 583 times
That piece is there to let him "punch" open the windshield half when you yank the gray lever back. Cut the rectangle into a triangle and you can keep that function intact, or cut the whole thing off if you don't need it. Up to you. Now look at the cylindrical section of the windshield kibble piece and note the 2 grooves molded in that let it slide onto the pegs on his forearm and rotate. You'll duplicate those grooves about a third of the way around the circumference of that section, as shown above.
Now flip the windshield kibble 180degs and snap it back into place. Voila, forearm armor where before there was but kibble before:
- P1000917.JPG (81.26 KiB) Viewed 583 times
I also tried to give his head some more range of movement, but that didn't turn out so good. More research is necessary. And cutting.
Some "After shots" (I know, I should have "Before" pics, but, as with virtually all my TF mods, I start examining the situation and before I know it, the hobby blade is out and little bits of plastic are flying all around.):
- P1000908.JPG (113.36 KiB) Viewed 582 times
- P1000909.JPG (116.91 KiB) Viewed 583 times
- P1000919.JPG (99.2 KiB) Viewed 581 times
One last tip: make sure your blade is sharp. Sharp blades are actually safer than dull ones, you know. My fingers could tell you some stories... Comments please and enjoy!
[ Click to attempt signal recovery... ]
