The Energon Pub

News Credits: 9 · by **Hip-Hoptimus Rime** » Fri Jul 27, 2018 12:39 pm

EDIT- Detailed pics added.

As good as SS Lockdown is, that huge backpack bothers me more every time I look at it. So I took it off by cutting slots into the tabs that hold the backpack onto its pin. Now it clips on and off easily.

Of course, without the backpack, he has a huge hole in his back. I separated the front end of the car kibble from the rest of it (it’s not pinned), and installed it on his back in the same position it would usually be. This left the wide front bumper sticking out out of his sides, so I just flipped the part over and clipped it back in. Now it covers most of the opening in his back, and the wide part of the bumper hides behind his shoulders.

The arm that holds the removed back kibble ends up sticking out, so I made a big notch in the back panel to let it swing upward some more. I also cut down a couple of ridges on the underside of the hood part to let that bracket swing up more too.

The result is a much leaner, meaner Lockdown. Partsforming, yes, but he ends up looking more accurate IMHO.

News Credits: 19 · by **Carnivius_Prime** » Sun Aug 05, 2018 11:17 am

Does look good. Not sure i wanna attempt it on mine though I did snip Ratchet's roof thingy so that it actually folded up under with the roof itself (i don't know why they didn't just do that in the first place, they had done on previous Ratchet deluxe figures).

The Energon Pub

Studio Series Lockdown backpack removal- detail pics

Studio Series Lockdown backpack removal- detail pics

Re: Studio Series Lockdown backpack removal- detail pics

Who is online

Forums

Transformers News

Transformers and More @ The Seibertron Store

Featured Products on Amazon.com

The Ultimate Caption Contest