The Energon Pub

News Credits: 3 · by **Midnight_Fox** » Sat Jan 08, 2011 7:30 pm

Rodimus Minor wrote:

How is Blurr holding him He has begs on the side but non on the bottom I have Painted my Spare Calaburst
Hawire 3 2.jpg

Reading is your friend.

What I did was take a 4.8 mm stryrene tube(a tip I got from another thread on these guys), wrap a couple layers of tape around it, and placed it in the minicon port on Caliburst's back. It Makes a better handle and makes this minicon a better Haywire.

News Credits: 13 · by **grimdragon2001** » Sat Jan 08, 2011 9:10 pm

yea, just take a 4.8 to 5mm styrene plastic tube, or a lego connector peg and place it into the minicon port. if it seems too loose a little tape will tighten it up nicely

News Credits: 1 · by **Rodimus Minor** » Sun Jan 09, 2011 10:09 am

Oh I see now my bad #-o

News Credits: 1 · by **AutobotMR2** » Sun Jan 09, 2011 10:52 am

I took the lego peg option since I could not get ahold of styrene, and it works wonderfully. You just have to sand down the section that does into his minicon port. Then I painted the "handle" with makes it fit better in his hand, and just super-glued it in.

News Credits: 36 · by **Pretender Skywarp** » Sun Jan 09, 2011 11:35 am

ausbot wrote:These should have been packaged with Blurr and Scourge!

These are Generation figs and as such are a homage to the original G1 series.

After we've all gone out and bough the first release, they'll re-release and repack them with the target masters, just like they did back in '87.

Then, just to kick us while we're down, the'll make them store exclusive too

by **Burnin12** » Wed Jan 19, 2011 3:04 pm

I did the same with my Caliburst. Added a peg (colored silver with a sharpy)to the bottom.

I am using the Nightstick that came with the BIS 2 pack for Blur though. I gave caliburst and Chopster (the one that comes with Smolder)to Grindcore and after some paint I'll have the Targetmaster/Wrecker Scoop....that's my plan anyway. Since the paint won't happen for a while I'll just live with a green Scoop.

News Credits: 1 · by **Rodimus Minor** » Wed Jan 19, 2011 3:24 pm

I used a Black tube peg from one off my Little brothers Bioncle figures it was a spare peg I didn't take it from his figure and i hand painted my Haywire