The Energon Pub

News Credits: 3 · by **buddha-con** » Wed Mar 28, 2007 9:55 pm

Would it be too far fetched to think that Hasbro might take reissues off of "hiatus", and try with some other characters after Soundwave? Or do you think after Soundwave Hasbro will be done?

by **Rodimus_Lantern** » Wed Mar 28, 2007 10:26 pm

This is Hasbro we are talking about here. When was the last time they did anything rational? Never.

News Credits: 2024 · by **Hotrod** » Wed Mar 28, 2007 10:31 pm

Who knows. The reason they went on hiatus the first time had more to do with their contract with Toys "R" Us which made them exclusive to TRU. And of course TRU marked them up so the later waves did not sell well. Hasbro may do more but I would not expect them to do more the one every once in a while with long lag times in between releases.

News Credits: 7 · by **Roadbuster** » Wed Mar 28, 2007 10:44 pm

it is far too early ot tell but I think we won't see any further G1 reissues from hasbro outside of any possible online store sales that are in limited quantity.

News Credits: 2 · by **Basketball Jones** » Wed Mar 28, 2007 11:58 pm

Ironhide and Ratchet seem likely to be reissued- both are movie characters and both have not yet been reissued in the United States.

The Ironhide mold is of lackluster quality, but that doesn't seem to be an impediment with the movie line.

Hmm...a Movie Reissue series would be interesting.

Series 1: to debut shortly after the film (in August, perhaps?)
Optimus Prime (large, more expensive figure)
Ironhide w/ Bumblebee
Starscream (repackaged Takara reissue with Megatron as pistol)
Jazz (can the Jazz mold take any more abuse?)

Series 2: perhaps around the holiday season
G2 Megatron (green version, large, more expensive figure)
Ratchet w/ Frenzy
Bonecrusher/Brawl/Barricade (three-pack in the fashion of TFC #16: Insecticons)

Since the G1 Megatron figure could never properly be released, the G2 tank is a solid figure at Prime's price point. If too many tanks are present in wave 2, one could switch the three-pack with Jazz.

Bumblebee and Frenzy will be packaged with the vans to add value to an otherwise unimpressive mold.

News Credits: 3 · by **buddha-con** » Thu Mar 29, 2007 12:04 am

Basketball Jones wrote:Ironhide and Ratchet seem likely to be reissued- both are movie characters and both have not yet been reissued in the United States.

The Ironhide mold is of lackluster quality, but that doesn't seem to be an impediment with the movie line.

Back before they cancelled the line, I was very excited that Ironhide, Trailbreaker, Ramjet and Thrust were "next" according to TRU's computers... I think they would have sold better than some of their previous choices, maybe they will pick up where there left off??...then again, probably no chance in that...

by **Ultra Prime** » Thu Mar 29, 2007 12:09 am

From what I understand Hasbro will not do anymore reissues after Soundwave. I agree that after the movie they could make a killing on reissues but I doubt that Hasbro has considered that.

There is also the issue of if other molds that have not been reissued still exist in good enough condition to make more reissues. Hell, at this point most of us are just concerned about Hasbro going forward with new molds/characters for the Classics & Alternators lines. I don't think we can include the reissues in that hope.

However, Takara/Tomy may pull a suprise out of there sleeve after the movie hits for all we know. Dinobots or remaining seekers (Thrust / Ramjet)? :PRAY:

News Credits: 2 · by **Basketball Jones** » Thu Mar 29, 2007 1:15 am

There is also the issue of if other molds that have not been reissued still exist in good enough condition to make more reissues.

First, it is obvious Hasbro has considered it. They are always looking for profit.

Ironhide, Ratchet, and Ramjet are intact, as Takara has reissued all of them. Even if Trailbreaker is not intact, he could most likely be salvaged using the Hoist mold.

News Credits: 1 · by **Leonardo** » Thu Mar 29, 2007 3:01 am

I'd be happy if they re-tooled the Ratchet and Ironhide molds for reissue. Just give them decent robot heads, a la the Datsun mold, even if they are still hidden behind the windshield (it worked in "The War Within").