The Energon Pub

by **MaikeruSama** » Tue Feb 27, 2007 8:39 pm

Well here is my problem ok you know the side of the cab on his robot modewhere it i on the side of his arm. Well one side is very loose and easily spins around, can some one tell me how to tichten it becuase i think its a pin not sure but you cant tighten it buy screwing it becuase 1 its way to small and 2 it dosent have a place for you to put the end of the screw driver in. Well can someone help me?

News Credits: 1 · by **Redimus** » Wed Feb 28, 2007 4:13 am

Sorry, I dont think there is any easy way to fix that problem. Only thing I can think of is to remove the pin holding it in completely, and replace with a new screw n nut, butthat'd invlove a bit of mucking about with sharp things, and might result in more tamage than good.

by **TaterX** » Wed Feb 28, 2007 1:36 pm

Try dabbing i tiny bit of clear nail polish off of the tip of a pin around the space where the two red hinges connect to hold the clear blue painted door and side panles meet. When dry it should create a bit of friction problem solved. Don't over do it now just a wee bit at arond the hinge perimiter. TX out.

by **MaikeruSama** » Wed Feb 28, 2007 5:25 pm

TaterX wrote:Try dabbing i tiny bit of clear nail polish off of the tip of a pin around the space where the two red hinges connect to hold the clear blue painted door and side panles meet. When dry it should create a bit of friction problem solved. Don't over do it now just a wee bit at arond the hinge perimiter. TX out.

Thank you im going to try it out.