The Energon Pub

News Credits: 1 · by **primematrix1986** » Sat Feb 01, 2014 1:47 am

Like the title said, is there any methods to tightening pin joints on figures? Please let me know below!

News Credits: 226 · by **Burn** » Sat Feb 01, 2014 1:54 am

I've always found clear nail varnish is handy. Easy to apply and just adds a little layer of thickness.

News Credits: 1 · by **primematrix1986** » Sat Feb 01, 2014 2:19 am

Burn wrote:I've always found clear nail varnish is handy. Easy to apply and just adds a little layer of thickness.

For ball joints, but I am talking about PIN joints. You cant disconnect pins without pulling them out, which I don't want to attempt.

News Credits: 226 · by **Burn** » Sat Feb 01, 2014 2:22 am

I'm well aware you're talking about PIN JOINTS. And my recommendation still stands.

Drip the nail varnish on, wiggle the joint back and forth, let the nail varnish work it's way in and it will tighten up.

News Credits: 1 · by **primematrix1986** » Sat Feb 01, 2014 3:16 am

Burn wrote:I'm well aware you're talking about PIN JOINTS. And my recommendation still stands.

Drip the nail varnish on, wiggle the joint back and forth, let the nail varnish work it's way in and it will tighten up.

Oh ok, I will try it out thanks!

News Credits: 226 · by **Burn** » Sat Feb 01, 2014 5:46 am

Well it's worked for me at least.

Others folks will have other recommendations though. So wait a couple of days and see what else is suggested. That way you can't come back and say "Dammit Burn! Your method ruined my TF!"