The Energon Pub

by **Wh33l Jck** » Thu May 23, 2013 10:01 pm

Hey everyone, I just wanted to get a small poll of how many people have messed up paint on the new Springer figure? The yellow paint on mine is pretty washed out below his shoulders. Even the green paint in some places is not opaque.

Also in car mode the sides of the front windshield don't peg in, and in helicopter mode the windshield does not peg in. Design flaw maybe or I just got a bad fig? I don't think I am transforming it wrong?

I just wanted to see how common these problems are, to see if I should try to get a new one?

I have to say I got in on the first shipment of the BBTS voyagers and both seem to have serious QC issues. It almost makes me wonder if it is best to wait so they work out the kinks on new releases???

News Credits: 60 · by **fenrir72** » Fri May 24, 2013 5:46 am

I think you should change the title to Springer QC issues............more responses.

by **STINGRAY749** » Wed Jun 26, 2013 11:59 pm

My Springer has horrible paint apps. The worst is that he has no

where it should be. This is why figures shouldn't be painted by machines. :BANG_HEAD:

News Credits: 1 · by **JackStraw** » Thu Jun 27, 2013 9:54 am

I have two Springers and the paint apps are ok, but I find the alt modes to be fiddly and have the same problems with the pegging in of the pieces.
I just picked up two Sandstorms and the paint apps are horrible. Missing paint apps on the head and the thigh's apps are light and splotchy.

News Credits: 12 · by **GuyIncognito** » Thu Jun 27, 2013 1:47 pm

I haven't noticed any problems with my Springer.

STINGRAY749 wrote: This is why figures shouldn't be painted by machines.

If they were hand-painted, they'd only be able to produce a small amount and they'd cost like $200 each. You want hand-painted TFs? Paint them yourself.

News Credits: 1 · by **SKYWARPED_128** » Thu Jun 27, 2013 8:08 pm

GuyIncognito wrote:If they were hand-painted, they'd only be able to produce a small amount and they'd cost like $200 each. You want hand-painted TFs? Paint them yourself.

Or get it custom painted. Depending on what you ask for, you could pimp out that Springer fig for a reasonable price. Unless you yourself are pretty handy with paints, in which case the only cost would be a few drops of enamel/acrylic.

by **STINGRAY749** » Sun Jun 30, 2013 1:48 am

GuyIncognito wrote:I haven't noticed any problems with my Springer.

STINGRAY749 wrote: This is why figures shouldn't be painted by machines.

If they were hand-painted, they'd only be able to produce a small amount and they'd cost like $200 each. You want hand-painted TFs? Paint them yourself.

Ya I'm never going to custom paint anything. I tried once, it wasn't pretty. And also I meant it sarcastically. >:oP

News Credits: 10 · by **Arctorro** » Sun Jun 30, 2013 4:49 am

STINGRAY749 wrote:
GuyIncognito wrote:I haven't noticed any problems with my Springer.

STINGRAY749 wrote: This is why figures shouldn't be painted by machines.

If they were hand-painted, they'd only be able to produce a small amount and they'd cost like $200 each. You want hand-painted TFs? Paint them yourself.

Ya I'm never going to custom paint anything. I tried once, it wasn't pretty. And also I meant it sarcastically.

Your original post made me think of Captain Fanzone :lol: