Ratchet plate problems

Post a reply

3 posts • Page 1 of 1

Ratchet plate problems

by Autobotic9 » Tue Oct 16, 2007 5:46 am

hi, for any ratchet owners, is it normal for the plates on the back of the thighs to fall off occasionally?

Skywarp is afraid of the creepy grey bar of ads.

A Terrifying...Terrorist. Silence! I kill you!

Autobotic9: Combiner; Posts: 406; News Credits: 2; Joined: Tue May 08, 2007 7:13 am; Location: Rhode Island

Top

by TK-225 » Tue Oct 16, 2007 5:51 am

Yes. I had this problem and have met many others who did as well. To solve this, put an extremely small spot of superglue on the edge of the peg AFTER you slide it through the hole on the thigh. Then you can put the rail back on and hold it tight for at least 30 seconds. If you did it right and didn't overdue the superglue it should still rotate as well as hold together. Good luck! :grin:

TK-225: Fuzor; Posts: 232; Joined: Thu Jul 26, 2007 8:14 am

Top

plate

by saintsfan1983 » Tue Oct 16, 2007 7:27 am

Thanks, my Rescue Ratchet did this the minute I took it out of the box. So now I know a dab of glue, and its good as new.

What Transformer are you? (Movie)

My Results:

Ironhide

You are the weapon specialist. You are probably the only Autobot who doesn't give a crud about the humans and repeatedly asks permission to blow something up. You are very strong and big as well as always suggesting the BIGGER sort of weapon. You are also good at sports; mostly contact sports. You can be easily irritated and may have anger issues. You also have a huge truck mode. Sweet.