The Energon Pub

by **Bonger** » Wed May 30, 2007 2:24 am

So I finally got my Primus with Unicron head the other day.

Like most, I agree that Primus is awesome and I won't get into all the good stuff there.

However, I was a little disapointed in 2 things.

#1 I felt there could have been more detail when in planet mode.

#2 When in Planet mode, the blue looks quite faded.

Anyone seen any nice pics of, or tried doing a repaint/kitbash of him?

Also, any ideas for a clear stand so that I can put Unicron in rotation over primus?

News Credits: 4 · by **GrimSqueaker** » Wed May 30, 2007 3:16 am

Dunno about the clear stand, but i had primus in plnet mode and unicron in robot mode meanacing him for ages on my shelf and it looked awesum! Right now i have them grabbling with each other-they are great fun to posse!

You could jtsy make a cylinder out of clear perspecs? If it is a high wieght it ought supposrt him

by **Godmodule** » Wed May 30, 2007 3:23 am

Flexidisplays work great.

by **Bonger** » Wed May 30, 2007 3:38 am

GrimSqueaker wrote:Dunno about the clear stand, but i had primus in plnet mode and unicron in robot mode meanacing him for ages on my shelf and it looked awesum! Right now i have them grabbling with each other-they are great fun to posse!

You could jtsy make a cylinder out of clear perspecs? If it is a high wieght it ought supposrt him

For the Orbit bit, I meant to put the Unicron head in orbit, like in season 3.

News Credits: 4 · by **GrimSqueaker** » Wed May 30, 2007 3:41 am

Bonger wrote:
GrimSqueaker wrote:Dunno about the clear stand, but i had primus in plnet mode and unicron in robot mode meanacing him for ages on my shelf and it looked awesum! Right now i have them grabbling with each other-they are great fun to posse!

You could jtsy make a cylinder out of clear perspecs? If it is a high wieght it ought supposrt him

For the Orbit bit, I meant to put the Unicron head in orbit, like in season 3.

That'd be cool-u could still use a perspecs cylinder. Just grab an A4 sheet of the ****, cut it, roll it, and plop the head on top (u might need to pin the roll if glue wont be strong enough)