The Energon Pub

News Credits: 2 · by **X3ROhour** » Fri Jul 12, 2019 3:30 am

A few months back
i seem to recall
that future cases with Starscream
were going to have a metal pin
put in place to keep the chest from falling off.

Does anyone else remember that?
is it just me?
not the first time i hallucinated about Transformers!

ANYWAY
Do you remember that?
has anyone seen any?

probably just me... :HEADHURTS:

News Credits: 2 · by **X3ROhour** » Fri Jul 12, 2019 3:33 am

https://www.seibertron.com/transformers ... pin/43091/

I FOUND THE ARTICLE!!!

i have been looking for fix screamers for months now!!
has anyone found this "fix"?

News Credits: 174 · by **Hellscream9999** » Fri Jul 12, 2019 3:56 am

Z3ROhour wrote:https://www.seibertron.com/transformers/news/running-change-found-in-transformers-war-for-cybertron-siege-starscream-added-chest-pin/43091/

I FOUND THE ARTICLE!!!

i have been looking for fix screamers for months now!!
has anyone found this "fix"?

No, it was confirmed to be someones custom fix getting passed off as a running change >:oP

News Credits: 4845 · by **william-james88** » Fri Jul 12, 2019 12:36 pm

Z3ROhour wrote:https://www.seibertron.com/transformers/news/running-change-found-in-transformers-war-for-cybertron-siege-starscream-added-chest-pin/43091/

I FOUND THE ARTICLE!!!

i have been looking for fix screamers for months now!!
has anyone found this "fix"?

did you read the article? It says at the bottom that its a hoax.

by **Optimum Supreme** » Fri Jul 12, 2019 7:46 pm

Nothing wrong with the chest on mine. No pin either. I bet some loud people just got a few bad ones, and overblew the "issue".

News Credits: 241 · by **Jelze Bunnycat** » Fri Jul 12, 2019 11:17 pm

Optimum Supreme wrote:Nothing wrong with the chest on mine. No pin either. I bet some loud people just got a few bad ones, and overblew the "issue".

It's possible the later releases and redecos has a slight change made to the sizing of the pieces involved. Ironhide had the same type of problem, the cause is the holes being too small for the pegs on the panel. Hopefully Crosshairs has some resizing done.