The Energon Pub

News Credits: 402 · by **Mkall** » Sun Jun 28, 2015 11:22 am

by **necr0blivion** » Sun Jun 28, 2015 2:24 pm

That's a handsome upgrade. I will consider picking it up at some point when it's released.

News Credits: 10 · by **Agamemnon** » Sun Jun 28, 2015 9:32 pm

necr0blivion wrote:That's a handsome upgrade. I will consider picking it up at some point when it's released.

I quite agree. Also, I never considered folding the doors in like that on the arms. Well done, Beelzeboss! I have a new configuration to differentiate Nightbeat from Bumbles...

News Credits: 1 · by **rpetras** » Mon Jun 29, 2015 6:38 am

I'm getting this!

I have a shapeways kit that replaces the chest, but one of the posts broke and had to be fixed and it is a bit delicate now.

by **Rated X** » Mon Jun 29, 2015 7:45 am

I like it. Shame they didnt go for the headmaster, but that would have been too small and delicate. So will there be a repaint for goshooter? Then I might actually buy him. I would also be down for a minerva version to customize an extra carzap which im sure the club will have plenty of next year.

News Credits: 1 · by **rpetras** » Mon Jun 29, 2015 10:17 am

I really wish Hasbro would have remolded the chest in the first place.

As you pointed out, this fig has a lot of repaint potential, and it would have been nice if they had done this from the start.

News Credits: 402 · by **Mkall** » Mon Jun 29, 2015 11:17 am

rpetras wrote:I really wish Hasbro would have remolded the chest in the first place.

As you pointed out, this fig has a lot of repaint potential, and it would have been nice if they had done this from the start.

Agreed. I hope that one of the lessons they take away from the Combiner Wars is how much a couple different body pieces can really separate a couple characters made from the same mold.

News Credits: 118 · by **megatronus** » Tue Jun 30, 2015 2:21 pm

Wow - that's fantastic looking. Not sure if the head is really necessary (the stock head does a fine job), but I'm definitely getting this.

Again... that IDW Bee mold is such a work horse.

News Credits: 1 · by **rpetras** » Wed Jul 01, 2015 9:32 am

megatronus wrote:Wow - that's fantastic looking. Not sure if the head is really necessary (the stock head does a fine job), but I'm definitely getting this.

Again... that IDW Bee mold is such a work horse.

It looks like the entire chest stalk and head assembly, the whole center transforming mechanism, are all replaced, not just the front of the chest and a head.