The Energon Pub

https://youtu.be/2WATdnc2h_A

Just something I want to point out... My Scorn had an problem from the factory. The robot arm that folds under the dinosaur's chest was put on backwards at the hing part. That's the red piece in the shoulder with the hinge between the two dinosaur arms. This prevented the robot arm from folding all the way down to his chest.

If ya got this problem, don't force the arm! You'll totally break it. It's an easy fix if you got the tools, and I'm a tool man so here's what I did. I popped off the dino arms since they're just on ball joints. There's a steel pin that runs between the two grey ball joints. One side is large, the other side is thinner. You want to tap the pin from the thinner side. I took a 1/16" pin punch and gently tapped it out as far as I could. The end of the pin is knurled so I just grabbed it out with pliers from there. That freed the robot arm, so I just flipped it around and put the pin back in the way I took it out. Now the robot arm lays against the dino chest properly. Slapped the dino arms back on and poof! Scorn is fixed.

So if ya go to get Scorn, check his arm out to make sure it's put on the right way. If you're not sure which way it should be, check out this pic:

http://news.tfw2005.com/wp-content/uplo ... rn-003.jpg

On the arm with the hand look at the grey elbow hinge. See that little lip on the red shoulder piece just above where the grey part attaches? It should point out to the left like in the picture, with the little window slot above it. If it points to the right and you can see the whole T slot like you can at the wrist and not just that window then it's on backwards and you're gonna have the same problem I did.