Seibertron.com Energon Pub Forums

by **Doubledealer93** » Fri Jun 26, 2009 6:12 pm

i was not sure where to put this, so sorry if it is in the wrong forum, any ways i am taking apart an extra ROTF leader prime and i cant get those little metal rods out. how do i get those out with out breaking the fig? thanks.

News Credits: 402 · by **Mkall** » Fri Jun 26, 2009 7:05 pm

I'm gonna move this to Transtopian Discussion

News Credits: 5 · by **zodconvoy** » Fri Jun 26, 2009 8:35 pm

Not all of them can be removed and the ones that can are a nightmare! I did it on 2 Cybertron Hardtops and it was a pain but those were only basic scale.

News Credits: 767 · by **Dead Metal** » Sat Jun 27, 2009 2:03 am

You'll need a hammer and a nail.
Take the nail, and get rid of the pointy sharp end, also the nail should fit into the metal rod hole so ti should be a little smaller then the pin you want to get out.
Find the end of the pin, the one that was driven into the plastic, you'll recognize it by the plastic it pushed out, also it is a smaller hole then the end that wasn't driven in.
Take you nail and stick it into the small end and use your hammer to drive it out, be careful not to drive your nail into the plastic!
Once your finished just drive em back in.