The Energon Pub

by **Cliff Jumper** » Tue Jun 28, 2011 8:50 pm

Sorry if this is a stupid question, but my Leader Ironhide's right shoulder is quite a bit looser than the left. Anyways I was wondering if I could use the super glue trick on his shoulder, or is this unrecommended for the pin joint?

Thanks for your help.

News Credits: 9 · by **Mykltron** » Wed Jun 29, 2011 6:27 am

You can do it for pin joints but you'll need to move the joint every few seconds for around half an hour to prevent it locking.

by **bdougwrx** » Wed Jun 29, 2011 6:33 am

The right shoulder on mine is looser than the left too, but not so much that he can't hold a pose. Did you try tightening the screw?

News Credits: 4 · by **freaky777** » Wed Jun 29, 2011 6:52 am

I have the same problem too, I think its the same for all IH figures. Bad Hasbro QC as usual. For me I'm not gg to do anything about it though as like the above poster said, poses are still pretty doable.