The Energon Pub

by **Uniprimus** » Wed Sep 05, 2007 9:27 pm

I am worried that the paint is going to melt off my transformers in my room. It is one of the warmest rooms in the house, being at about 75 degrees. Is this an ok temperature and if notwhat should I do????

by **Dispensor** » Wed Sep 05, 2007 9:32 pm

Eradicator wrote:I am worried that the paint is going to melt off my transformers in my room. It is one of the warmest rooms in the house, being at about 75 degrees. Is this an ok temperature and if notwhat should I do????

That's not hot enough to melt the paint.

News Credits: 972 · by **i_amtrunks** » Wed Sep 05, 2007 9:47 pm

I'd be more worried about the humidity's general effect on your figures.

Not much you can do about humidity though.

by **Uniprimus** » Wed Sep 05, 2007 10:05 pm

What do you mean? And it is not realy humid, just warm.

by **HoosierDaddy** » Wed Sep 05, 2007 10:43 pm

Actually 70 - 75 degrees would be an ideal temp to keep action figures in. Not even close to high enough of a temp to harm your figs. Like stated above, humidity would have a worse effect in that any metal parts may rust or stickers could start peeling. If you don't have humidity issues, 75 degrees will be fine.

by **Bonger** » Wed Sep 05, 2007 11:43 pm

Are you implying that 75 is hot? :???:

by **Vegitron** » Wed Sep 05, 2007 11:48 pm

75 degrees is freezing! I have mine set at 79 and that's a little on the cold side. Then again it's 110 outside.

Eradicator wrote:I am worried that the paint is going to melt off my transformers in my room. It is one of the warmest rooms in the house, being at about 75 degrees. Is this an ok temperature and if notwhat should I do????

by **Uniprimus** » Fri Sep 07, 2007 9:16 am

Actually, I mesn to soften the paint so it comes off easier. That's what I'm worried about.

by **lanzajr26** » Fri Sep 07, 2007 9:24 am

I doubt that 75 degrees is hot enough to soften the paint or any of their parts, even if you live in high humidity. Now if we're talking 90 degrees and up then you might have some problems (warping, peeling).