The Energon Pub

First of all thanks to Maximo Prime (of SECTOR70)who's idea it was that i write this guide.

Tools you will need;a modelling knife,a selection of small needle files,some very fine wet & dry sandpaper,
some spray undercoat/primer and most importantly some sculpting material (personally i use Green stuff).

Step one.
Take apart the head and using a file or modelling knife open up the mouth area as wide as possible


Be carefull to not to damage the "lug" that the screw fits into when the head is reassembled..


This is how the front of the head looks at this stage..


Next fill the hole with Green Stuff..


Trim off any excess with a modelling knife..


Now using a sculpting tool begin to carve the mouth..

When you are happy with the shape leave to dry for at least 12hrs.

Now using a wet finger lightly smudge over the green stuff,this smooths out the surface nicely(please note i don't know how well this will work with other sculpting materials).


Next using a fine grade sandpaper sand down the green stuff as smoothly as you can..


Now i spray a light coat of undercoat..


This will show any imperfections or areas that require any additional sanding.

Using VERY fine sandpaper sand again..

And undercoat again.

Repeat this process until the face is smooth..


Finally a couple of general tips.
Look in comic books for some great expressions to copy & if you don't have any sculpting tools get friendly with you're dentist,chances are you might be able to scavenge a few of his old sculpting tools.

thanks, nice how to. Now for your next assignment, give us a how to to get rid of the pearlman chin of doom.

Asphalt22 wrote:thanks, nice how to. Now for your next assignment, give us a how to to get rid of the pearlman chin of doom.

"pearlman chin of doom" classic
Ahh yeah i should have mentioned that.
Just cut it off with a razor saw

Well done.

Wow, good job! Can you clatify what that "green stuff" is? And can you use it to make a crest for galvatron?

chaz02 wrote:Wow, good job! Can you clatify what that "green stuff" is? And can you use it to make a crest for galvatron?

"Green stuff" is a 2 part epoxy putty comonly used in miniture sculpting.
You can get it from Games Workshop,ebay & some modelling stores.
It can be used to make pretty much anything.
Heres a link to a great guide to its many uses..
http://oz.games-workshop.com/hobby/mode ... efault.htm

Nice! It's great to be able to give the Seeker clones a little more personality.

One question: once you unscrew the head, how do you get the halves apart without damaging either of them? I'm trying something similar with a few Deluxe Animated Bumblebees (there's plenty of repaint options), but I haven't been able to crack the heads open; I'm not sure if it's just friction or if there's some sort of glue involved. What do you suggest?

I wouldn't order it from Games-Workshop, you can buy a lot more for a lot less from other places. It's also called kneadatite