The Energon Pub

News Credits: 665 · by **Skowl** » Wed Mar 12, 2008 11:27 am

On top of the new Cyber Slammer galleries, Ryan has also posted some photos of the new Jungle Bonecrusher figure from the Transformers Movie 'Allspark Power' toyline.

See the photos by clicking here.

by **Defcon!** » Wed Mar 12, 2008 12:42 pm

Unless i really like the original mold or the color scheme i may or may not get repaints. I'll probably pass on this one.

by **Megatron-Ron** » Wed Mar 12, 2008 12:44 pm

I love this figure. I am happy that i picked it up when i came across it. It was the only one left on the shelf.

News Credits: 387 · by **Nekoman** » Wed Mar 12, 2008 1:22 pm

Defcon! wrote:Unless i really like the original mold or the color scheme i may or may not get repaints. I'll probably pass on this one.

I have Bonecrusher and JB and to tell you the truth, JB is much, much better. Mainly I say this because I can barely get my Bonecrusher’s claw to stay up whereas JB has much tighter joints and can pose better.

I would say you should consider him.

News Credits: 2 · by **Stockade** » Wed Mar 12, 2008 8:42 pm

I recently got JBC and his right leg joint is getting lose by the min and the claw arm wont stay together truck mode and definetly wont up in robot mode!!! anyone had this problem or any problems with JBC, i have reg BC and all joints, arms, legs, and arm claw is very tight!! I guess i'll take switch him out with another JBC and see what happens.

by **Predacon Galvatron** » Wed Mar 12, 2008 9:46 pm

Stockade wrote:I recently got JBC and his right leg joint is getting lose by the min and the claw arm wont stay together truck mode and definetly wont up in robot mode!!! anyone had this problem or any problems with JBC, i have reg BC and all joints, arms, legs, and arm claw is very tight!! I guess i'll take switch him out with another JBC and see what happens.

My Jungle Bonecrusher is fine. But I'm curious, which joint is loose on the right leg? If it is the ball joint, then you can apply some clear Finger Nail Polish to it.

News Credits: 2 · by **Stockade** » Fri Mar 14, 2008 10:14 pm

To Megantron the great, thanks for the info about applying clear finger polish to the ball and socket joint and most of all, I applied several coats of it to the tip of the arm were it attaches to the front of the truck and it help alot! I mean alot, stiffen it right up and instead being loose all the time. so again thanks.

P.S. i just love Jungle bonecrusher, so much better looking!!!