Darth Zax wrote:dammit GlauG, these look amazing.
My money is burning in my pocket, when will i be able to buy this stuff?
Keep it up
SW's SilverHammer wrote:Eat my ass funpub.
Burn wrote:And this is for taking Nemesis Maximo seriously.
*high fives Silly in the face*
carytheone wrote:I can't be assed to do any better right now.
SW's SilverHammer wrote:Eat my ass funpub.
Burn wrote:And this is for taking Nemesis Maximo seriously.
*high fives Silly in the face*
carytheone wrote:I can't be assed to do any better right now.
Delta Magnus wrote:This stuff looks pretty amazing! I have Blender and I'm hoping to make some stuff to sell on ShapeWwys myself- I already have an idea for a figure I could make.
A few questions:
1: I know the Shapeways guys will fix imperfections/errors in 3D models if the model you send them isn't quite right (so if there's a small gap in the mesh); what are they prepared to fix and what will simply get the model rejected (I assume they'll tell you why it was rejected though)? So for example, if a model isn't quite manifold due to a few minor oversights, will they be prepared to fix that error?
Delta Magnus wrote:2: Do multipart models have to be printed on a sprue? So could I just send them a model of, say, a simple figure with the parts separated (I know I couldn't send it with it "assembled" as it would end up printed fused) or would I have to model it onto a sprue?
Delta Magnus wrote:3: Can NURBS surfaces be used in models for printing?
SW's SilverHammer wrote:Eat my ass funpub.
Burn wrote:And this is for taking Nemesis Maximo seriously.
*high fives Silly in the face*
carytheone wrote:I can't be assed to do any better right now.
SW's SilverHammer wrote:Eat my ass funpub.
Burn wrote:And this is for taking Nemesis Maximo seriously.
*high fives Silly in the face*
carytheone wrote:I can't be assed to do any better right now.
Registered users: Bing [Bot], Google [Bot], Google Adsense [Bot], Google Feedfetcher, Hero Alpha, MSN [Bot], o.supreme