Ravage XK wrote:The paint on the part of the car where the right hand wing mirror is mounted is very thin. This allows the black plastic underneath to show through which makes the red much darker than any of the rest. There are also a few small chips here and there. I see general differences in red across may panels, you notice it at the joins, it's not terrible but I would have expected some care to be taken for something so expensive.
zappatton2 wrote:I see a couple of screws, could you take it apart and reassemble correctly? I wonder if this is a common defect. I got my shipping confirmation, guess I'll find out next week :/
robotmel wrote::-(
Its getting pretty disapointing to hear about the QC problems of MP-12 Lambor/Sideswipe.
Come on takara, whats all this about?
I have finally got some up-close pictures of my faulty version which I bought via China based Ebay seller 366offer.
Mkall wrote:robotmel wrote::-(
Its getting pretty disapointing to hear about the QC problems of MP-12 Lambor/Sideswipe.
Come on takara, whats all this about?
I have finally got some up-close pictures of my faulty version which I bought via China based Ebay seller 366offer.
Question: Did you get one mint in box? I'm wondering if you got a factory reject, i.e. one that didn't pass QA.
robotmel wrote:Mkall wrote:robotmel wrote::-(
Its getting pretty disapointing to hear about the QC problems of MP-12 Lambor/Sideswipe.
Come on takara, whats all this about?
I have finally got some up-close pictures of my faulty version which I bought via China based Ebay seller 366offer.
Question: Did you get one mint in box? I'm wondering if you got a factory reject, i.e. one that didn't pass QA.
Think I probably did... No box, just wrapped! Im sure Takara wouldnt allow this through QC, no way!
I hope the seller comes back to me soon with a resolve.
Mkall wrote:robotmel wrote:Mkall wrote:robotmel wrote::-(
Its getting pretty disapointing to hear about the QC problems of MP-12 Lambor/Sideswipe.
Come on takara, whats all this about?
I have finally got some up-close pictures of my faulty version which I bought via China based Ebay seller 366offer.
Question: Did you get one mint in box? I'm wondering if you got a factory reject, i.e. one that didn't pass QA.
Think I probably did... No box, just wrapped! Im sure Takara wouldnt allow this through QC, no way!
I hope the seller comes back to me soon with a resolve.
I'm sorry to say that I think you've been taken for a ride. If you payed with PayPal it may be better to file a complaint through them.
Mykltron wrote:Pin removal is generally done with a nail and a large hammer? It's often a pain in the arse? The plastic around the hole will get a bit damaged as the nail always slips to the side a bit?
If you send it to me and cover the return postage cost I can have a go, but in return I'd ask that you stop ending non-question sentences with a question mark?
If someone else who is better at pin removal and doesn't consider it a pain in the arse wants to do it instead of me then they're welcome.
SKYWARPED_128 wrote:Depending on how small the pin is, you can use a really small screwdriver
Mykltron wrote:SKYWARPED_128 wrote:Depending on how small the pin is, you can use a really small screwdriver
Oooh, thanks for the tip, I'll use a braddle which is even smaller.
Return to Transformers Toys Discussion
Registered users: Bing [Bot], Glyph, Google [Bot], Google Adsense [Bot], Majestic-12 [Bot], Yahoo [Bot]